Aluminum Rain Gutter Infographic

ALUMINUM RAIN GUTTERS SECTION LEAF SCREEN SECTION IS ALSO KNOWN AS THE GUTTER. A GUTTER IS A RESERVOIR WHICH RUNS HORIZONTALLY TO THE A BARRIER SCREEN ON TOP OF THE HANGER GRAPHIC CREATED BY: GUTTER WHICH PREVENTS THE BUILD UP OF DEBRIS WITHIN THE GUTTER. STRUCTURE IN WHICH ITS AFFIXED, RAIN GUTTER PROS INC HANGERS SUPPORT THE GUTTERS AND HOLD THE GUTTERS TO THE STRUCTURE, COLLECTING RAIN WATER FROM THE HANGERS ARE FIXED TO THE www.RAINGUTTERPROSINC.COM ROOF AND REDIRECTING ITS FLOW. STRUCTURE USING SCREWS EVERY FOUR (4) FEET. OUTSIDE CORNER INSDIE CORNER ENDCAP THE END-CAP STOPS THE FLOW OF WATER WITHIN THE GUTTERS AND ARE TYPICALLY LOCATED WHERE THE ROOF CEASES TO ANGLE DOWNWARD. DEPENDING ON THE MATERIALS USED FOR THE END-CAPS AND GUTTERS, END- CAPS ARE INSTALLED USING A WATER RESISTANT CAULKING COMPOUND OR SOLDER INSIDE & OUTSIDE CUSTOM CORNERING WHERE TWO GUTTERS MEET, TYPICALLY AT A 90 DEGREE ANGLE AND SEAMLESSLY FUSED TOGETHER USING OVERLAPPING TECHNIQUES, HIDDEN SCREWS, SPIKE & FERRULE CAULKING COMPOUND OR SOLDER, ELBOWS - DEPENDING ON THE MATERIAL USED. HANGER ELBOWS ARE A SERIES OF CUSTOM TRANSITIONAL TUBING WHICH CONNECT A HANGER METHOD WHICH CONSISTS OF BETWEEN THE GUTTER AND THE DRIVING A SPIKE THROUGH THE ENTIRE DOWNSPOUT WHILE LAYING FLUSH WIDTH OF THE GUTTER AND INTO THE AGAINST THE STRUCTURE'S EXTERIOR STRUCTURE. TUBING SPACERS WALL. THERE ARE TYPICALLY THREE (3) SECTIONS TO AN ELBOW. SURROUNDING THE SPIKES ARE USED ALONG THE WIDTH OF THE GUTTER TO PREVENT WARPING. HANGERS USING THIS METHOD ARE TYPICALLY PLACED STRAP THE STRAPS HOLD THE DOWN SPOUT DOWNSPOUT • AGAINST THE STRUCTURE'S EXTERIOR WALL. THE DOWNSPOUT IS A SECTION OF TUBING WHICH RUNS VERTICAL TO THE STRUCTURE'S EXTERIOR WALL AND DIRECTS WATER FLOW DOWNWARD FROM THE GUTTERS. SPLASH BLOCK THE SPLASH BLOCK ALLOWS WATER TO EXIT THE DOWNSPOUT AND FURTHER REDIRECTS ITS FLOW AWAY FROM THE STRUCTURE'S EXTERIOR WALL. SPLASH BLOCKS ARE TYPICALLY MADE OF PLASTIC OR CONCRETE.