Click me
Transcribed

How To Make A Ethernet Cable

1000tables FT Call: 800 759 7253 WE OPTIMIZE YOUR COMMUNICATIONS NEEDS How To Make Ethernet Cable ? Step 1- Strip Cable End Strip 1 - 12" of insulating sheath Avoid cutting into conductor insulation Step 2 - Un-twist wire ends Sort wires by insulation colors Step 3- Arrange wires TIA/EIA 568A: GW-G OW-BI BIW-O BrW-Br TIA/EIA 568B: OW-O GW-BI BIW-G BrW-Br PC STRAIGHT-THRU CABLES HUB TX+ 1 1 RX+ TX- 2 2 RX- RX+ 3 3 TX+ 4. RX- 6 6 TX- PC CROSS OVER HUB TX+ 1 1 TX+ TX- 2 2 TX- RX+ 3 1 3 RX+ RX- 6 6 RX- 8 8. Step 4 - Trim wires to size Trim all wires evenly Leave about ½" of wires exposed mm inches, 1/8 Step 5- Attach connector Maintain wire order, left-to-right, with RJ45 tab facing downward Step 6 - Check Do all wires extend to end? Is sheath well inside connector? 123 4 5 678 123 4 5 678 ИННИ ННИ Step 7 - Crimp Squeeze firmly to crimp connecter onto cable end (8P) Crimp Tool After Crimping Step 8 - Test Does the cable work? CABLE TESTER RU45+ RUTI OFF ON S REMOTE NS-46 MASTER Use of this Web site constitutes acceptance of the 1000FTcables.com Privacy Policy. © Copyright 2014 1000FTcables. All Right Reserved. 1000FTcables.com | [email protected] | 800 759 7253 (in 8*

How To Make A Ethernet Cable

shared by robert.robertkey on Apr 09
143 views
0 shares
0 comments
In This info-graphic you are going learn how make an Ethernet cable, with all the steps described in detail so you could make your very own networking cable.

Publisher

1000ft Cables

Tags

None.

Source

Unknown. Add a source

Category

Technology
Did you work on this visual? Claim credit!

Get a Quote

Embed Code

For hosted site:

Click the code to copy

For wordpress.com:

Click the code to copy
Customize size