Click me

Block Paving Driveway Installation Guide

Block Paving Driveway Installation Guide Steps of Installation Remove Existing Surface Remove top surface to atleast 250mm for paving driveway. Set Level Line Install timbers at house end and pavement side. Further attach nylon line to get paving height. ..... ...... Set Geotextile Layer 3. Geotextile layer over surface of sand Geotextile layer Place geotextile layer to eliminate mixing of subsoil and hardcore. over surface of | gravel Sand layer Gravellayer ...... .... .. Spread & Compact the Hardcore Spread hardcore to a depth of 150mm to form base for block. Use vibrating roller for its compaction. Solid Edge Surrounding 5. Surround block paving by solid edge to avoid block and sand creeping. Spread Grit Sand 6. Spread grit sand atleast 20mm higher than finished height for compacting. Install Block Install block into sand to allow final compacting. 8. Use Flat bed .............. .............. ........... Use galvanized steel electric conduit so it can slide along to screed the sand. Block Paving Laying Firstly lay the full block in straight line and then lay to complete the area. 10. Brush Driveway Brush driveway to remove broken pieces of block so that joints remain free from debris. Estimated Driveways Cost 10 20 30 I Gravel Asphalt Concrete Brick EARTHEXIT LTD Powered by : SURFACING CONTRACTORS

Block Paving Driveway Installation Guide

shared by Martinpaul on Oct 01
Block paving driveways are an asset to an home or a place and its installation also gives attractive look to home.


block service


Did you work on this visual? Claim credit!

Get a Quote

Embed Code

For hosted site:

Click the code to copy


Click the code to copy
Customize size